Nova 23067 Manuel d'utilisation et d'entretien télécharger pdf (Page 18)

Screw in any Teknatool insert in the chuck thread. Engage the thread partially and tap on the

back of insert with a mallet. You will see that the backing plate starts to come off. Remove the

backing plate

Now using two flat head screw drivers gently push together to lift both sides of the plastic backing

plate evenly. Do not try to force the backing plate out as this may damage the plastic plate.

Remove the plastic backing plate completely thus exposing the pinions and back of the scroll

ring.

The Pinions can now come out by hand, as illustrated in the photo above.

Removing scroll ring from Chuck

Turn the chuck upside down to remove the scroll ring

Removing jaw slides by hand

Now push manually push the jaw slides.

Maintenance of the Supernova

chuck

Clean each of the four jawslide with a cloth removing any grit, wood, dust particles etc.

Clean the Scroll ring of all grease, grit, wood etc

Clean each of the two pinions of all grease, grit, wood etc

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25

Pas de commentaire

Nova 23067 Manuel d'utilisation et d'entretien Page 18