Nova 23067 Manuel d'utilisation et d'entretien télécharger pdf (Page 16)

SuperNova

Chuck Maintanence

This guide covers all steps, beginning from when your chuck is on the lathe; you may wish to skip

several steps in order to advance to where you are currently at.

Tools needed: 1½” spanner

Circlip pliers (and safety glasses)

3mm Allan key (provided with Supernova 2 chuck)

Plastic hammer (or block of wood)

Also you will need multi purpose grease for re-greasing chuck when re-assembling

Removing The Supernova

from the Insert and Wood lathe

The Supernova 2 chuck on a Nova 3000 DVR lathe

Removing grub screw to release insert

Using the 3mm Allan key provided with the Supernova, release the M6 grub screw (turning in an

anti-clock wise direction to loosen)

Using 11/2" Spanner to remover chuck from lathe

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 24 25

Pas de commentaire

Nova 23067 Manuel d'utilisation et d'entretien Page 16